Adding Soft Close To Existing Cabinet Drawers

The right slide is the guide.

Adding soft close to existing cabinet drawers.

Once both were in place you could try to slam the. Then attach the soft close adapter to the plywood. Mark placement with a pencil. The blum 563h soft close drawer slides are my first choice for new kitchen or furniture quality drawers.

Instructions line up the slow close rods exactly with the drawer slides. Screw 1 piece onto the drawer and the other piece onto the cabinet to set up the slide. The easy way to update your drawers to make them soft closing is to install rockler soft close adapters to your existing epoxy coated slides and you don t have to replace the slides. Repeat at the rear.

Align the glide flush with the bottom of the drawer being sure the small extending part of the glide is positioned to the front of the drawer. The titus add on soft close for wood or melamine drawers is designed for easy installation without measuring. Put the bit through the screw hole as you hold the soft close attachment in place. Place the new hinges into the mortises from the old hinges.

Hold the soft close attachment up to the top corner of the cabinet door so the flat edge sits behind the edge of the cabinet and the knob juts out just beyond the edge. However if you have a face frame cabinet you ll have two steps. Step 2 drill a starter hole with a 3 32 inch drill bit attached to the electric drill. Attach a piece of plywood or scrap wood noted above to the right side drawer slide.

Like other undermount soft close slides they are invisible once installed come packaged with locking hardware rear mounting brackets and are full extension so the drawer is completely opened. Using the screwdriver unscrew the hinges holding the cabinet doors to the cabinet and remove the doors. New slides are made up of 2 pieces. If your slides are not mounted straight onto the cabinet.

Make sure it lines up with the rod. An easy answer to adding a soft close to almost any existing drawer that has a 1 2 side clearance. Well if you ve ever wished for quieter closing drawers. Screw marked glide into place predrilling holes if desired.

You put one piece on the bottom of the drawer as close to the front as you can. Then you put the drawer back in to mark where the second piece will go inside. Available for face frame or box style frameless cabinet construction. Unscrew the hinges from the cabinet doors using the screwdriver.

Turn the drawer over and repeat on the other side. If the new screw holes don t line up you ll. Line up the plastic piece that goes onto the outside of the drawer itself. The second piece comes with a guide all you have to do is line up your mark in the window screw in the unit and remove the guide.