Add Canned Lights To Ceiling On First Floor

Cut slot in ceiling and fish cable.

Add canned lights to ceiling on first floor.

Sketch an accurate lighting plan. Cut a hole into the ceiling with a drywall saw. Then press the can up until it s flush with your ceiling. How to install recessed lighting between floors.

Then press the four tabs through the light fixture until they sit flush against the can. Position the clips off center by about 7 inches then cut enough wire to run between each clip and the main ceiling grid plus 24 inches of extra wire to complete a securing wrap at each attach point. Cut the hole with a drill with a hole cutting attachment and mark all light locations. It is easier to tap into an existing circuit via a receptacle than to run.

Hold a ceiling electrical box against the ceiling where you will install the fixture and trace the outline of the box. Reach through the recessed light holes to drill through joists that aren t accessible from the slot in the ceiling. Turn off the power to the room at the main circuit breaker. Make sure you do not snag any wires that may be in the ceiling cavity.

You can use an existing power source but if that is not an option then use a switch controlled. 6 feed the junction box and the arm of the light fixture into the ceiling hole. Locate an available branch circuit to use as a power source. Place an old work electrical.

Make sure the tabs lock into place. To make sure you get the installation right the first time around draw up a. Install four suspension clips two on each side to the floor joists above the ceiling tile. Cutting a hole in your.

Hold the recessed light housing up to the ceiling in the desired installation location. Use chalk lines to ensure that the. When installing recessed lighting in an existing ceiling a hole is cut in the ceiling that exactly fits the profile of a special remodeling can to keep from damaging the surrounding drywall. How to install recessed lighting without access to the attic.